Page 47 - kodascope-b

of the Kodascope- 45

Cutting

Take the other or wigllt hand
piece of film and place it, emul-
sion or dull side down, over the
eight pins on the block so that
one whole picture will extend
beyond the two extreme left end
pins. Place the guide plate over
the film with the end of the guide
plate marked "cut" to the left.
Cut off the projecting end of the
film , Fig. 40.

Cementing
Removetheguideplate and the
film from the block; apply a little
(Jr Lhe Kodascope Film ement on the end of the back or shiny
:-~ i d < of the right hand iilm, and wipe it off immediately. This will
IPn,v a dull surface to which t he cement will stick more evenly.
l< <'place the right hand film , emulsion side down, over the four
ri ,.ll L hand pins; this bri og the end of the film in the center of
Llw block. Place the left; ban l filrn , emulsion side down, over the
l'ou r left hand pins; t he . craped end will project nvpr the end of
IIH' right hand film.
II old the films in place with
Lh<' left hand, lift t h craped
<'''d with the left second ftnger,
:1nd a pply a liberal coating of
<·r'ment with t he brush along
Lllr underside of the scraped
<'ncl of the left hand film, sec
l~'i g. 41. Immediately press
Lh ·nels of the film together
wi Lh a finger of the left hand
:\nd bold it firmly in place
for igbt or ten seconds.
It move the spliced film Fig. 41
I' rom the block and press the cemented portion between the fingers
I o insure good con tact, and wipe off any excess cement from
IHd ll f>ides.